Nice MC824HR, Инструкции и предупреждения по установке и использованию

Страница: 6 / 28

6 – ENGLISH
ELECTRICAL CONNECTIONS
4
4 ELECTRICAL CONNECTIONS
4.1 PRELIMINARY CHECKS
The electrical connection of the various devices present on
the automation (photocells, digital keypads, transponder card
readers, etc.) to the control unit must be made through the
Nice “Bluebus” system. For the other connections, refer to that
specified below.
f
All electrical connections must be made with the
system disconnected from the mains electricity and
with the back-up battery (if present) disconnected.
a
The connection operations must only be carried out
by qualified personnel.
f
Mount a device on the electric power line that
completely disconnects the automation from the
grid.
– The disconnection device must have contacts with a
sufficient gap to ensure complete disconnection, under
the Category III overvoltage conditions, in accordance
with the installation instructions. If necessary, this
device guarantees quick and safe disconnection from
the mains power and therefore must be positioned
in sight of the automation. If located in a concealed
position, it must be equipped with a system that
prevents inadvertent or unauthorised reconnection of
power, to avoid potential hazards.
4.2 WIRING DIAGRAM AND DESCRIPTION OF CONNECTIONS
4.2.1 Wiring diagram
M1
M2
TX
NO NO NO NO
NO
NC
8K2
FLASH
RX
EL
24V 4W
OGI
Bluebus Bluebus
Close Open SbS Stop
OGI
ENC
ENC
ELS
Flash
Bluebus
M
M
1 2 3 4 5 6 7 8 9 10 11 12
M
M
Nice S.p.A. Via Callalta, 131046 Oderzo TV Italy
Fuse 15A
7
4.2.2 Description of connections
The meaning of the codes/wording stamped on the electronic board near the relative terminals is described below.
Table 2
ELECTRICAL CONNECTIONS
Terminals Function Description Cable type
Motor 1
Connection of motor M1 [ note 1 ]
3 x 1.5 mm
2
Motor 2 Connection of motor M2 3 x 1.5 mm
2