Nice MC824HR, Инструкции и предупреждения по установке и использованию

Страница: 14 / 28

14 – ENGLISH
LEVEL 1 FUNCTIONS (ON-OFF)
LED Function Description
L4 Stand-by all
Function ENABLED: 1 minute after the manoeuvre is completed, the control unit will turn off the “Bluebus”
output (connected devices) and all the LEDs, with the exception of the Bluebus LED, which will flash at a
slower speed. When the control unit receives a command, it restores normal operation (with a short delay).
This function is used to reduce consumption – an important aspect when the unit is powered by batteries
or photovoltaic panels.
L5
Electric lock /
Courtesy light
Function ENABLED: the “electric lock” output switches its operation to “courtesy light”.
Function NOT ENABLED: the output functions as an electric lock.
L6 Pre-flashing
Function ENABLED: the warning light starts flashing 3 seconds before the start of the manoeuvre to
signal in advance a dangerous situation.
Function NOT ENABLED: the warning light starts flashing when the manoeuvre starts.
L7
“Close” becomes
“Partial Open 1”
Function ENABLED: the “Close” input of the control unit switches its operation to “Partial Open 1”.
L8 Automatic 1
Function ENABLED: with the gate open and “automatic closing active”, during the pause time the
commands coming from the inputs and from the radio receiver are disabled. The operation of these
commands is restored when the pause time expires, immediately after the closing manoeuvre has started.
Function NOT ENABLED: the commands also function during the pause time.
6.3 LEVEL 2 PROGRAMMING (ADJUSTABLE PARAMETERS)
All the Level 2 parameters are factory-set as highlighted in “ GREY ” in “ Table 7 ” and can be modified at any time. The parameters
can be set to a scale of 1 to 8. The check the value corresponding to each LED, refer to “ Table 7 ”.
6.3.1 Level 2 programming procedure
m
The user has maximum 10 seconds to press the buttons consecutively during the programming procedure,
after which time the procedure terminates automatically and memorises the changes made up to then.
To perform Level 2 programming:
1. press and hold the
g
button until LED “ L1 ” starts flashing
2. release the
g
button when LED “ L1 ” starts flashing
3. press the
f
or
h
button to move the flashing LED to the “ entry LED ” associated with the parameter to be
modified
4. press and hold the
g
button. With the
g
button pressed:
– wait roughly 3 seconds, until the LED representing the current level of the parameter to be modified lights up
– press the
f
or
h
button to shift the LED associated with the parameter’s value
5. release the
g
button
6. wait 10 seconds (maximum time) to exit the programming mode.
l
To set multiple parameters during the procedure's execution, repeat the operations from point 2 to point 4
during the phase itself.
l
The set value highlighted in grey (“Table 7”) indicates that this value is the factory setting.
Table 7
LEVEL 2 FUNCTIONS (ADJUSTABLE PARAMETERS)
Entry
LED
Parameter
LED
(level)
Set value Description
L1 Pause Time
L1 5 seconds
Adjusts the pause time, in other
words, the time that elapses before
automatic re-closure. It is only
effective if the Close function is
enabled.
L2 15 seconds
L3 30 seconds
L4 45 seconds
L5 60 seconds
L6 80 seconds
L7 120 seconds
L8 180 seconds