- 99 -
NEW LEADER • NL5000G5 AGCO
www.New-Leader.com
(800) 363-1771
314520-AA-A
Page Rev. A
Header
Controller Operations
CREATING A NEW PROFILE
NOTE:
When creating a new profile for a new material to be spread, spread pattern tests must be
conducted. Spread pattern testing at low and average application rates ensures proper spinner
position for given spreader output. Refer to “Spread Pattern” section of manual for details.
•
Press
on the Swath Module tab under Profile
Management to create a new profile.
•
Activate bins to be run on profile by selecting the icons
on the display.
•
Press
to continue.
•
Enter material density for each bin. crush strength and
SGN are not required, but it is recommended to add the
information if proper measurement tools are available.
•
Press
to continue.
NOTE:
A crush strength and SGN test kit is
available. See “Spread Pattern” section of
manual for details.
•
Enter spinner speed, application speed (ground speed)
and desired swath width.
NOTE:
Spinner speed and swath width are
determined from crush strength and
SGN. See “Spread Pattern” section of
manual for details.
•
Press
to continue.