NETGEAR ProSafe WNAP320, Справочное руководство, Страница: 49 / 93

28 | Chapter 3. Management
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Restoring the WNAP320 to the Factory Default Settings
You can restore the product family to the factory default settings using the Restore function..
To restore the factory settings:
1.
Select
Maintenance > Reset > Restore Defaults
. The Restore Defaults screen
displays.
Figure 7.
2.
On the Restore Defaults screen, select the Yes radio button, as shown in
Figure 7,
.
3.
Click
Apply
to reset to the factory default settings.
After a restore, the product family password will be
password
, the WNAP320 DHCP client
will be disabled, the default LAN IP address will be
192.168.0.100
, and the access point
name will reset to the name printed on the label on the bottom of the unit.
To restore the factory default configuration settings when you do not know the login
password or IP address, you must use the reset button on the rear panel of the product family
(see
Figure 2
on page 14). The reset button has two functions:
• Reboot.
When this button is pressed and released, the wireless access point reboots
(restarts).
• Reset to factory defaults.
This button can also be used to clear all data and restore all
settings to the factory default values.
To clear all data and restore the factory default values:
1.
Power off the WNAP320.
2.
Using something with a small point, such as a pen, hold the restore settings button for 5
seconds while you power on the WNAP320.
3.
Continue holding the restore settings button until the LEDs blink twice.
4.
Release the restore settings button.
The factory default configuration has now been restored, and the WNAP320 is ready for
use.