30
|
Chapter 2. Installation and Configuration
ProSafe Wireless-N Access Point WNAP320 Reference Manual
–
IP Subnet Mask
: Enter the subnet mask value used on your LAN. The default is 255.255.255.0.
–
Default Gateway:
Enter the IP address of your LAN Gateway. For more complex networks, enter
the address of the router for the network segment to which the wireless access point is connected.
The default is 0.0.0.0.
–
Primary and Secondary DNS Servers
: Enter the IP address of the Domain Name Server (DNS)
you wish to use. The default is 0.0.0.0.
4.
Spanning Tree Protocol
. Enable or disable spanning tree protocol. Spanning tree protocol
provides network traffic optimization in settings with multiple ProSafe Wireless Access
Points. The default is Enabled.
5.
Enable 802.1Q VLAN
. Check the radio box to accept 802.1Q VLAN to allow the WNAP320
to process VLAN membership. The default is disabled.
6.
From the pull-down men, select the local
Time Zone
setting for your location.
7.
Check the
Adjust for Daylight Saving Time
if your location uses daylight saving. The
default is no adjustment.
Note:
You must have an Internet connection to get the current time.
8.
Click
Apply
so save your Basic IP settings.
