NetApp StorageGRID Webscale SG6000 Series, Руководство пользователя

Страница: 30 / 174

Information needed Your value
Static IP address you plan to use for the appliance
Storage Node on the Grid Network
Note: If your network does not have a gateway,
specify the same static IPv4 address for the gateway.
• IPv4 address (CIDR):
• Gateway:
Grid Network subnets (CIDRs)
Information needed to connect SG6000-CN controller to Client Network
The Client Network for StorageGRID is an optional network, typically used to provide client protocol access to
the grid. The appliance connects to the Client Network using the 10/25-GbE ports on the SG6000-CN
controller.
Information needed Your value
Client Network enabled Choose one:
• No (default)
• Yes
Network bond mode Choose one:
• Active-Backup (default)
• LACP (802.3ad)
VLAN tagging enabled Choose one:
• No (default)
• Yes
VLAN tag(If VLAN tagging is enabled) Enter a value between 0 and 4095:
DHCP-assigned IP address for the Client Network, if
available after power on • IPv4 address (CIDR):
• Gateway:
Static IP address you plan to use for the appliance
Storage Node on the Client Network
Note: If the Client Network is enabled, the default
route on the controller will use the gateway specified
here.
• IPv4 address (CIDR):
• Gateway:
Information needed to connect SG6000-CN controller to BMC management network
You can access the BMC interface on the SG6000-CN controller using the following 1-GbE management port.
This port supports remote management of the controller hardware over Ethernet using the Intelligent Platform
28