4-6 Installing Options
Replacing the Cover
Replace the cover as follows.
Ensure that all cables inside the chassis are
positioned to prevent crimping, abrasion, or cutting while installing the
cover. Check that the ribbon cables are folded along their fold lines and
out of the direct path of the cover.
1.
Position the cover over the side of the chassis so that the back edge of
the cover is about an inch beyond the back edge of the chassis (see
the following figure).
2.
Align the tabs and slots on the cover with those along the edges of the
chassis.
3.
Align the locking tab slot at the bottom rear of the cover with the
locking tab.
Aligning the cover
A – Side Slots and Tabs
C – Front Slots and Tabs
B – Locking Tab (hidden)
