Nautel NX100, Руководство по предварительной установке

Страница: 70 / 99

NX100 Pre-installation Manual Planning control/monitor connections
Issue 3.2 2017-03-31 Page 8-1
Section 8: Planning control/monitor
connections
This section describes the types of control and monitoring for the NX100 transmitter. Consider this
information and plan for the necessary requirements (wiring, remote switches/indicators, LAN, etc.):
• AUI control (local and remote)
• External system interlock - see page 8-2
• External PDM inhibit - see page 8-4
• Remote inputs - see page 8-5
• Remote outputs - see page 8-9
• Analog outputs - see page 8-12
• Web based control - see page 8-13
• SNMP Control/Monitoring - see page 8-14
• Nautel Phone Home - see page 8-15
AUI control (local and remote)
The NX100’s front door contains an advanced user interface (AUI) that allows you to locally control
all transmitter functions and set parameters and schedules.
The remote AUI allows you to adjust any parameter and view any status available in the local AUI via
a web browser on a computer connected to the LAN connector on the single-board computer’s
motherboard (A1U1) on the back of the control cabinet’s front door.
The NX100 also allows control and monitoring through an Ethernet connection via SNMP,
supporting version 1 of the protocol, with traps.
The local or remote AUI also allow you to configure the remote inputs to control various transmitter
functions and monitor the transmitter’s status by means of a conventional, parallel wire remote
control interface (see
“External system interlock” and “Remote outputs” on page 8-9 ) or an Ethernet
connection (see “Web based control” on page 8-13 ).
For detailed information about the AUI, refer to the NX100 Operating and Maintenance Manual .