Nautel NX100, Руководство по предварительной установке

Страница: 79 / 99

NX100 Pre-installation Manual Planning control/monitor connections
Page 8-10 Issue 3.2 2017-03-31
Table 8.3: Remote Outputs - Selection Options
Remote Output Description
Remote Enabled
Status
Indicates the local/remote control status of the transmitter. Logic true if transmitter is in
remote mode. Logic false if transmitter is in local mode. Changes can only be made
remotely if the transmitter is set to remote mode. The local user’s control of transmitter
operation is limited, unless the transmitter is set to local mode.
Indicates the on/off status of the transmitter’s RF power stage. Logic true if RF is enabled. RF On/Off Status
Active Exciter Status Indicates which exciter is presently active. Logic true if exciter A is active. Logic false if
exciter B is active.
Auto Changeover
Status Indicates the status of the auto changeover function. Logic true if enabled (auto). Logic
false if disabled (manual).
Main Exciter Status Indicates which exciter is selected as main. Logic true if exciter A is main. Logic false if
exciter B is main.
Indicates the status of the mode scheduler function. Logic true if enabled (scheduler). Logic
false if disabled (manual).
Scheduler On/Off
Status
Various Alarms
Logic true condition indicates the associated alarm is occuring. Logic false if it is not
occuring.
AUI Watchdog Status Must be configured as Remote Output 1 . Indicates that a watchdog reset is occurring,
due to an error in communication between the Controller and the single-board computer.
Preset Status Indicates that the associated user-named mode is currently active.
Max Power Lockout
Status Indicates that a maximum power lockout limit (1 to 8) has been selected..Logic true if the
lockout has been selected. Logic false if the lockout has not been selected.
Remote Input Mimics the logic of the associated remote input selection. Example: If Remote Output 5 is
set to Remote Input, it will mimic the logic received on remote input pin 5. This is typically
used for debugging remote inputs.