NARGESA MP3003 CNC, Инструкция, Страница: 62 / 112

ANEXO 1. SOFTWARE ESA S630 A44
Changing the bend sequence
Once the bend sequence has been optimised, it will be possible to change the bending sequence obtained:
The operator has the possibility of moving among the various bends by pressing the and buttons.
To remove the bends it is necessary to press the
[Bend] key in correspondence of the selected bend,
remove the other bend you wish to exchange, and press [Bend] to select the new sequence desired on
each bend removed.
3.6 How to bend a box
The numeric control does not allow to directly set the development on the flat of a box to be bent.
To be able to bend a box it is necessary to set a program with two bend sections (it doesn't matter if the
program is graphic or numeric) in which to set the bends relating to the horizontal section and the bends
relating to the vertical section respectively.
The two programs will be realized one after the other, thus making it possible to create the box.
The execution of a program with several sections always starts from the section with the
smallest width of the sheet metal.
How to add or delete a section
To add a section in graphic or numeric, it is necessary to press the function key [Change Section] whereas
to delete a section, move onto the desired section and follow the steps below:
- Press the button to open the menu.
- Select the item
6>> Delete section ; the section will be deleted and the program will move onto bend 1 of
section 1.
3.7 Work data
It is possible to check the absolute TDC, Mute and Pinch Point of a bend, in the following manner:
- Press the button to open the menu.
- Select the item
7>> Work informations ; a window will appear containing the absolute TDC, Mute and
Pinch point.
- To exit press
[Ok].
3.8 Execution of a program in automatic mode
After setting a numeric program or calculating a graphic program it is possible run it in automatic.
Automatic mode can be enabled by pressing the button.