NARGESA MP3003 CNC, Инструкция, Страница: 40 / 112

ANEXO 1. SOFTWARE ESA S630 A22
- Press [Ok];
- Enter the value of the angle a2, touching with a finger on the field;
- Press
[Ok].
The die drawing will form by continuing to alternatively enter the lengths and angles. More the entered
measurements and angles correspond to reality, more the drawing will be correct.
Entered data correction
Incorrect entries may be made during drawing entry.
Is it possible correct these entries moving amongst the various drawn with the and buttons and
by modifying the values of the fields.
- Use the button to switch to the immediately previous entry field and then alternatively pass to a
length entry field “l” and an angle entry field “alpha”.
- The button immediately passes to the next length and, thus, always to the length entry Field “l”
Square V-die entry
The die drawing page can be used to enter square V-die. To enter one of these, execute the following
operations when on angle entry Field α of the length prior to the V-die:
- Press
[Square V-die].
This accesses the square V-die data entry window.
- Enter the depth “h” of the V-die, touching with a finger on the field;
- Press
[Ok];
- Enter the width “l” of the V-die, touching with a finger on the field;
- Press
[Ok];
- Enter radius “r” of the V-die, touching with a finger on the field;
- Press
[Ok];
- Enter the V-die “load” (maximum tons for meter) , touching with a finger on the field;
- Press
[Ok]; the square V-die will be drawn with the entered data. The cursor will return to the polar data
description window in order to describe the next die length.
Square V-die conventions
If a square V-die has been entered, the minimum bend angle that can be made is the angle corresponding
to a V-die of the entered width and depth.