NARGESA MP3003 CNC, Инструкция, Страница: 59 / 112

ANEXO 1. SOFTWARE ESA S630 A41
Simulation
Once the solution has been accepted, it will be possible to simulate the bending sequence obtained in the
optimisation window of the graphic program:
- Press the function key
[Simulate], the piece without bends, set up and ready for the first bend will be
displayed.
- Press the function key
[Rest/Support], as many times as necessary, to select the first support, the second
support (if available) or the rest of the piece. Obviously the stop will only move into the supported position if
there aren’t collisions and if the limits of the axes permit.
- Press the function key
[Continue], the piece will be displayed with the first bend already made.
- Press the function key [Continue], the piece will be displayed with the first bend already made and in
position for the second bend.
- To stop the simulation press the function key
[Stop], to return to the previous step in the simulation press
the function key [Previous].
- Press the function key [Continue], until the end of the simulation (the function key [Simulate] will reappear)
Rest/support mode
Once the solution has been accepted, it will be possible realize a support bend in the optimisation window
of the graphic program:
- Press the function key
[Simulate], the piece without bends, set up and ready for realize the first bend will
be displayed.
- Press the function key
[Rest/support], as many times as necessary, to select the first or second
supporting of the piece (if available), obviously the stop will only move into the supported position if there
aren’t collisions and if the limit heights of the axes permit.
- Press the function key
[Continue], the piece will be displayed with the first bend already made.
- Press the function key [Continue], the piece will be displayed with the first bend already made and in
position for the second bend.
- Press the function key
[Rest/support] as many times as necessary, to select the first or second supporting
of the piece (if available), obviously the stop will only move into the supported position if there aren’t
collisions and if the limit heights of the axes permit.
- To stop the simulation press the function key
[Stop], to return to the previous step in the simulation press
the function key [Previous].
- Press the function key [Continue], until the end of the simulation (the function key [Simulate] will reappear)
- The function is displayed in the numeric program at the top, on the right hand side of the type of bend.
The control automatically calculates the corrections necessary on the X and the R. The function key
[Rest/
support], in numeric mode will not work if the program is graphic. To change the rest/support it is
necessary to enter the simulation page.