MYERS MP Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 149

21
STEP 3: Connect the output or Signal Cabinet and Battery
Figure 7
MP2000E Front Panel
STEP 4: Connect the Utility Input Line Power
DANGER: Make sure the upstream circuit breaker feeding the
utility power is OFF before beginning this step. Leave the
NEUTRAL and GROUND wires connected from utility to
signal cabinet. Extend the NEUTRAL and GROUND wires
from their corresponding bus bars in the traffic cabinet to the
terminal block on the PTS . between utility and traffic cabinet.
4.The cabinet side HOT wire is
connected to "L OUT" on the
PTS.
5. The utility side HOT wire is
connected to "L IN" on the
PTS.
6. Torque the PTS terminal
block to a maximum of 10.0
lb-in (1.1 Mm).
LINE IN
START
WIRING FINISHED
Power
Transfer Switch
Connect the Black & Red control wires from the
PTS to the MP2000E Control
TB 21 & 22 respectively or plug into
PTS connector on face of BBS
Plug the cord from BBS IN on PTS to
AC IN Quick Connect Connector on the
MP2000E or AC INPUT terminal block
Connect the suppli ed black wire from
the L OUT terminal at PTS to the
al in the signal INPUT HOT termin
cabinet .
Plug the Red & Bla ck Battery connector
into the MP 2000 E BBS
1 . The wires from Ground
and Neutral Bus Bars
from the traffic cabinet
are extended to PTS
as Terminal Block
shown in step
2 . upstream the OPEN
breaker feeding utility
signal the to power
cabinet .
3 . Disconnect the HOT wire
( Black ) connected
START
GO TO STEP 4
Figure 6
Power Transfer Switch
L OUT
Figure 8
NEUTRAL
GROUND