Chapter 5 Maintenance and Inspection
UD-series Screw Compressor
5.4 Disassembly and Inspection
5-17
5.4.2 Shaft Seal Block (125
~
320)
Mechanical Seal assembly
P/N
Part Name
101
100
Mating ring
Stationary
rings
102
Insert lock pin
103
O-ring
109
Seal collar
Rotating
rings
111
Seal collar set screw
112
O-ring
528
Note
Oil seal sleeve
529
Note
Set screw for oil seal sleeve
744
Note
O-ring
48
Retainer, oil seal
49
O-ring
50
Oil seal
20
Spring pin
Note: [528], [529], [744] are not used to 125,160 models.
Figure 5-4 Details of BBSE-type Mechanical Seal Assembly and Related Parts
Disassembly
a) Of the eight hexagon socket head cap screws [53] securing the seal cover [51], remove six bolts
leaving two diagonally opposite bolts.
b) Loosen the remaining two screws alternately and evenly, a little at a time. When the screws are
loosened to some extent, the seal cover will be pushed by the spring force of the seal to create a
gap under the cover. The gap will not be created if the gasket is sticking to both surfaces. In this
case, free the cover by screwing M8 eye bolts into the jacking screw threads on the seal cover to
separate it.
c) As the oil inside will flow out through the gap, be ready to receive the oil with a container.
d) Pull out the seal cover in the direction of the rotor shaft axis. Inside the cover, there is the mating
ring fitted with the O-ring. In this, carefully remove the seal cover for the mating ring not to be
damaged by touching the shaft.
e) Remove the O-ring [49] between the seal cover and oil seal retainer [48].