User’s Guide DrafStation and Drafstation Pro
Chapter 3: Basics
39
AP-75730, Rev. 2.1, 19/01/2009
Step 4 :
Slide the roll media (1) into the media feed slot (2) as shown on the image below.
N° Name
1 Roll
media
2 Media
feed
slot
Notes
•
Make sure the roll media is properly wound up on the media core.
•
If the front edge of the roll media is not straight, cut it straight, using the cutter blade.
•
If the front edge of the roll media is curled, cut it off, using the cutter blade.
•
For the cutting method, refer to topic “Cutting media”
Step 5 :
Open the front cover (1), and pull out the roll media (2) about 0,5 m.
N° Name
1 Front
cover
2 Roll
media
Step 6 :
Verify that the right edge of the roll media does not cover the media loading mark (2). See image
below.
N° Name
1 Roll
media
2
Media loading mark
