User’s Guide DrafStation and Drafstation Pro
Chapter 5: Preparations before printing
107
AP-75730, Rev. 2.1, 19/01/2009
Step 3 :
Measure the distance between two pluses in the initial adjustment print using a measurement
tool, such as a ruler.
Step 4 :
Set up Initial Change.
•
Press the [+] key or [–] key to select "PF: Init.Change".
•
Press the [Enter] key on the operation panel.
o
The operation panel displays "Init: 250.0/250mm".
•
Press the [+] key or [–] key and enter the measured value in step 3.
•
Press the [Enter] key on the operation panel
o
Saves the initial adjustment value.
o
The operation panel displays "PF2: Init.Adj.Change".
Step 5 :
Perform the Confirm Print.
•
Press the [+] key or [–] key to select "PF: Confirm Print".
•
Press the [Enter] key on the operation panel.
The operation panel displays "Feed Length: 250 mm".
Notes
•
The length that media is fed (feeding length) for confirmation adjustment printing is normally set at 250
mm.
•
If you make the feeding length longer, the accuracy of the Media feed compensation improves.
If you want to change the feeding length, press the [+] key or [–] key and change the set value.
•
Press the [Enter] key on the operation panel.
o
The operation panel displays "Printing".
o
Start Confirmation adjustment printing.
N° Name
1 Feed
length
2
Media feeding direction
•
After the confirmation adjustment printing, cut the media. See
“ Cutting media”
Step 6 :
Measure the distance between two pluses in the confirmation adjustment print using a
measurement tool, such as a ruler. Then, confirm that the distance matches the feeding length
when printing.
•
If the distance does not match the feeding length, follow the procedure from 1 to 5 and
readjust.
•
If the distance matches the feeding length, proceed to step 7.
