User’s Guide DrafStation and Drafstation Pro
Chapter 7: Troubleshooting
137
AP-75730, Rev. 2.1, 19/01/2009
7.2.5 Error requiring a restart
This section describes the details of the display when an error requiring a restart occurs and its remedy.
An error requiring a restart is displayed if a fatal operational failure such as the following occurs.
•
When an obstacle which prevents printing occurs.
•
When a problem occurs with the electrical circuit (PCB, motor, sensor, etc.) of the plotter.
•
When a failure on the plotter control program occurs.
If an error requiring a restart occurs, the plotter stops operating after performing the following operations.
Step 1 :
The power automatically shuts down.
Step 2 :
All lights on the operation panel blink, and the buzzer rings continuously.
Step 3 :
The error message is displayed on the operation panel.
Pressing any key on the operation panel stops the beeping.
For an error requiring a restart, operation will return to normal after removing the cause of the error and
restarting the plotter.
If the same error continues to be displayed, contact your local MUTOH dealer. Be sure to tell us the code no.
of the error message when you contact us.
N° Display
Description
Remedy
Reference
1
E** Error
[ ]
A problem that does not
have a remedy.
1. Remove obstacles such as paper scraps
in the drive system.
“The media is jammed”
2. Confirm that the replaced items are
correctly attached.
“Replacing consumable
components”
3. Switch off the plotter power, and switch it
on again after more than 10 seconds.
Notes
•
"***" in the error message is the code no. that indicates what type of error occurred.
•
The command code representing the error occurred is indicated in [ ].
•
For the settings on your PC side, refer to the Operating Guide of your PC.
