Multitech CommPlete CC2400, Руководство по установке системы и быстрому запуску

Страница: 89 / 113

2 Configuration Quick Start
89
11. Type the address for your backup DNS server, or press E
NTER
to accept
the default address of 0.0.0.0 if you do not have one. When you press
E
NTER
, a screen similar to the following one appears that shows your
new network defaults and presents you with the System Defaults Setup
menu:
Default Gateway (-(previous), q (uit), <192.168.4.1>):
Subnet Mask (-(previous), q (uit), <255.255.255.0>):
Primary DNS Server (-(previous), q(uit), <192.168.11.251>):
Backup DNS Server (-(previous), q(uit), <0.0.0.0>):
System Defaults Setup
1. Network Defaults
2. Ras Defaults (Required)
3. Ras Security Defaults (Required)
4. T1 Defaults (Required)
5. E1 Defaults (Required)
6. PRI Defaults (Required)
Enter Selection (-(previous), q(uit), <2>): 2
12. When you press E
NTER
, the following menu appears:
Frame Type
1. TYPE_II
2. SNAP
Enter Selection (-(previous), q(uit), <1>):
13. Type the number of the frame type used by your network, or press
E
NTER
to accept the default. TYPE_II is the standard Ethernet frame
type. SNAP is supported only by some older UNIX systems. When you
press E
NTER
, the following menu appears:
Address Method
1. via DHCP server
2. Address pool
3. Per port config
4. RADIUS
Enter Selection (-(previous), q(uit), <3>):
14. Use the Address Method menu to specify how IP addresses will be
allocated to the remote users. Select via DHCP server if you have a
DHCP server on your LAN. Select Address pool if the IP addresses you
assign to the clients are continuous. Select Per port config if you want to
assign a specific address to each remote port. Select RADIUS if you want
to use your RADIUS server to assign IP addresses. Type the number of
the address allocation method you want the RAS to use, or press E
NTER
to accept the default. When you press E
NTER
, the following menu
appears:
Wan Port IPCP
1. Disabled
2. Enabled
Enter Selection (-(previous), q(uit), <1>):