Multitech CommPlete CC2400, Руководство по установке системы и быстрому запуску

Страница: 102 / 113

System Installation and Quick Start Guide
102
Saving Defaults .... Done
64. The following prompt appears:
[0] A:\ #
Type se to enter the MultiCommManager Environment Setup menus.
MultiCommManager Installation
65. Install the MultiCommManager software on your supervisor PC.
66. Open the MultiCommManager Explorer window and select Physical
View
.
67. Click Add to create in the Explorer an IP site for the CommPlete
controller and servers. Enter the IP address of the controller, a unique
long name, and a unique three-letter short name. Click OK.
68. Double-click Physical View. You should see the name of the new site
next to a green “IP.” If the “IP” is gray, double-check your IP settings.
Also, make sure the Read Community and Write Community settings
match how they are set on the MR9600 controller.
69. Double-click the IP site you just created, double-click on the Group icon,
then double click the Rack icon. You should be able to see the modems.
70. Select the RAS device by highlighting the RAS icon and choosing the
appropriate slot (1A, 5A, 9A or 13A).
71. Select the Edit button to check the Read and Write Community strings
for the RASCard.
Installation is complete. If you need to change any settings, you can do so from
MultiCommManager or by using Telnet to access the CommPlete controller and
servers.
Getting Version Information
To complete the site information sheet, you should verify the installed
versions and record the information. Follow the procedures in the Verifying
Software/Firmware Version Information
section at the end of this chapter.