Multitech CommPlete CC2400, Руководство по установке системы и быстрому запуску

Страница: 41 / 113

2 Configuration Quick Start
41
2. Ras Setup
3. T1 Setup (Required)
4. E1 Setup (Required)
5. PRI Setup (Required)
Enter Selection (-(previous), q(uit), <2>): 2
RASCard Setup
Note: as you configure the RASCard, make note of your settings on the
T1 Site Information sheet.
49. Verify that all RASCards are turned on. Type 2 and press E
NTER
to set up
the RASCards. The following line appears:
Select a Ras Card (1A, 5A, 9A, 13A, -(previous), <d>(one)):
5A
50. Type the device number of the RASCard you want to set up and press
E
NTER
. Valid device numbers are listed in the option line. The Use
Settings From menu appears:
Use settings from:
1. Use Active Settings (pre-configured card)
2. Use System Defaults (new card)
Enter Selection ( q(uit), <1>:
51. Type 1 or press E
NTER
if you want to use or modify the settings stored in
the currently selected RASCard. Type 2 if you want to use or modify the
default RAS settings. The controller displays a screen similar to the
following with the options displayed varying based on the Address
Method selected:
Getting Ras Info ......
1. IP Address :192.168.4.151
2. Subnet Mask :255.255.255.0
3. Default Gateway :192.168.4.1
4. Primary DNS Server :0.0.0.0
5. Backup DNS Server :0.0.0.0
6. Frame Type :TYPE_II
7. Address Method :Address pool
8. Address Pool Start :192.168.4.200
9. Address Pool End :192.168.4.247
10.Start 1
s t
Exclusion :0.0.0.0
11.End 1
st
Exclusion :0.0.0.0
12.Start 2
n d
Exclusion :0.0.0.0
13.End 2
nd
Exclusion :0.0.0.0
14.RAS Express Password :********
15.Protocol :Local
16.Primary Server :0.0.0.0
17.Secondary Server :0.0.0.0
18.Shared Secret Password :********
Enter Selection (-(previous), q (uit), d(one), <1>: 2
52. Verify the settings for each option. To change a value, type the number
corresponding to menu item.