Multitech CommPlete CC2400, Руководство по установке системы и быстрому запуску

Страница: 74 / 113

System Installation and Quick Start Guide
74
29. Press E
NTER
and the MultiCommManager Environment Setup menu
reappears:
MultiCommManager Environment Setup
1. System Defaults Setup
2. Device Specific Setup (Required)
Enter Selection (q(uit), <2>): 2
30. In the MultiCommManager Environment Setup menu, select option 2
and press E
NTER
to set up the individual devices in the CommPlete. The
options that are most important to set now are the IP addresses for the
controller and the IP addresses for each RAS. If these are not properly
set, you will be unable to remotely configure the CommPlete.
Device Specific Setup
1. Controller Setup (Required)
2. Ras Setup (Required)
3. T1 Setup (Required)
4. E1 Setup (Required)
5. PRI Setup (Required)
Enter Selection (-(previous), q(uit), <1>):
Note: As you proceed with the individual device configurations that
follow, you will be brought through some of the same parameters that
were configured during the System Defaults Setup. In such steps, verify
that the options are correct and press E
NTER
to accept the defaults.
MR9600 Controller Setup
Note: as you configure the controller, make note of your settings on the
PRI Site Information sheet.
31. Type 1 and press E
NTER
to configure the controller. A screen appears
that shows the controller’s current settings:
IP Address (-(previous), q( uit), <0.0.0.0>): 192.168.4.150
1. IP Address
:192.168.4.150
2. Date : 9/25/2000
3. Time :8:11am
4. Default Trap IP :0.0.0.0
5. Default Gateway :192.168.4.1
6. Subnet Mask :255.255.255.0
7. Read Community :********
8. Write Community :********
Enter Selection (-(previous), q (uit), d(one), <1>):
32. Verify the settings for each option. To change a value, type the option
number of the value you would like to change and press ENTER. Type
the new value and ENTER.
When you have entered all the necessary changes, type d and ENTER.
Proceed to the MR9600 Controller Setup step #42.