MC40 Integrator Guide
Procedure Steps
1
Align the battery with the slots in the battery compartment.
Figure 1-1
Inserting the Battery
2
Lower the battery and press down until it snaps into place.
3
Press down on the battery latch.
4
Press the Power button to turn on the MC40.
1.2.2 Charging the Battery
Ensure that you follow the guidelines for battery safety described in
10.2 Battery Safety Guidelines,
Before using the MC40 for the first time, charge the main battery until the Right light emitting diode (LED)
turns solid green (see
Table 1-1 Battery Charge LED Status
for charge status indications). To charge the MC40,
use a cable or a cradle with the appropriate power supply. For information about the accessories available for
the MC40, see
The MC40 is equipped with a memory backup battery that automatically charges from the fully-charged main
battery. When using the MC40 for the first time, the backup battery requires approximately 36 hours to fully charge.
This is also true any time the backup battery is discharged, which occurs when the main battery is removed for
several hours. The backup battery retains random access memory (RAM) data in memory for at least 10 minutes
(at room temperature) when the MC40’s main battery is removed, when Battery Swap feature is used. When the
MC40 reaches a very low battery state, the combination of main battery and backup battery retains RAM data in
memory for at least 48 hours.
1-2
MN000112A01 - September 2013