© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANLWRPCROVR01 09-16-20
www.motorcitywashworks.com
9
Cotton Cloth™ Loading Instructions:
Bring
the two
HUB ASSEMBLIES
to your working area and remove the two compression plates from the
top of the hub. Slide
4
PVC STRIPS
into each channel (see Picture #14) and temporarily hold them in
place with a small piece of masking tape.
Open
the washing material boxes and start loading the hub with
THREE FOAM SPACERS,
followed by
ONE COTTON CLOTH™ RING,
and then
TWO FOAM SPACERS.
Continue until you’ve installed a total
of
12 CLOTH RINGS
(See Picture #15 below)
.
Finish with
THREE FOAM SPACERS.
Next, load
ONE 10” X 48” OD-1/8” BUN, TWO 10” X 54” OD-1/8” BUNS, ONE 10” X 60” OD-1/4”
and
finally
ONE 8” X 60” OD-1/4” BUN.
Reinstall the two compression plates and mount the hub to the main
shaft.
Pic #14 Star Foam Hub Pic #15 Star Foam Hub Assembly Pic #16 Star Foam Hub Assembly
C Channel Foam Loading Installation:
Mount
the two
HUB ASSEMBLIES
on each arm as shown in Picture #17 below. You may set the bottom
of the hub
BETWEEN 8” to 10” OFF THE FLOOR.
To CHANGE THE HEIGHT OF THE HUBS,
remove one core from the hub assembly and loosen the
CLAMPS
holding the cores in place (as shown in Picture #18 and 19). Raise or lower the entire core
assembly. Re-tighten the clamps in the new position. Re-install the core piece.
10” X 48”OD-1/8”
12 PCS @ 44” OD
8” X 60”OD-1/4”
10” X 60”OD-1/4”
10” X 54”OD-1/8”
10” X 54”OD-1/8”
(4) FOAM SPACERS
(2) FOAM SPACERS
