© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANLWRPCROVR01 09-16-20
www.motorcitywashworks.com
40
Maintenance:
DAILY:
Check for hydraulic leaks, chaffed hoses electrical cable, etc.
Visually inspect for any signs of wear.
Move the arms manually and duplicate its regular motion and look for abnormalities: A loose fastener may
allow some parts to move or rub and may create a dark stain running down the equipment.
Start the day with a TEST WASH and check for proper operation.
While you are watching the TEST WASH, check for clogged nozzles. If a nozzle is clogged, remove the
nozzle body (see Picture #48) and clean the nozzle by inserting a small piece of wire (a small paper clip or
wire will do fine!) in the nozzle opening.
Check for proper coverage of the two Streamer™ Foamers if applicable.
Check for the overall performance of the equipment on the vehicle: Profiling, cleaning, etc.
Wash down your equipment and the surrounding area at the end of each day.
MONTHLY:
Each piece of MCWW equipment is assembled with the highest quality bearings which have been factory pre-
lubricated, therefore it does not require supplemental grease for at least the first month of operation.
Use any lithium-based NLGI #2 grease (ex: Exxon Mobil MOBILITH AW2).
WARNING
!
OVERLUBRICATION IS A MAJOR CAUSE OF BEARING FAILURES!
LUBRICATE CONSERVATIVELY!
Lubricate monthly (with WD40) the Primary Arm limit switch head assembly in order to prevent the switch
rotating stem from sticking because of corrosion.
After the first month of operation, grease each bearing (see Picture #49-54).
Wash your equipment with a solution made of a mild degreaser and water. Rinse thoroughly.
Perform daily maintenance.
