© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANLWRPCROVR01 09-16-20
www.motorcitywashworks.com
33
Optional Wrap License Plate Bump Retract Kit:
Equipment Specifications and Features
Convenient 115VAC Air Solenoid Valves (Optional 24VAC available)
Compact Design: Utilize No Additional Space
Retract Both Wheel up to 18” off Center Line
Suggested Installation Tools and Materials
Set of Standard Combo Wrenches
3/8” OD Polyflow Tubing
Standard Screw Drivers
Set of Standard Ratchet and Sockets
6FT Step Ladder
Plastic Ties
Installation Instruction for Cross-Over™ Wrap Around
Open
all boxes and crates, and verify that you have all the required components as well as all your
installation material.
If
you have purchased your optional
WRAP LICENSE PLATE BUMP
separate from your
Cross-Over™
Wrap Around,
you have to install the system into your existing wrap around module.
Remove
the
PASSENGER’S SIDE SECONDARY CYLINDER
and the
CLEVISES
from the arm.
Remove
also
ROD END CLEVIS, JAM NUT,
and
RUBBER BUMPER
from the cylinder and reassemble
on the
NEW BUMP RETRACT CYLINDER
(see Picture #2).
Pic 1: Cylinder End Attachment
Pic 2: Cylinder Rod End Attachment
Secure
the front and rear mount on the arm and mount the cylinder (as shown on Pictures #1 and 2).
Repeat
same with the
DRIVER’S SIDE
.
In the mechanical room,
Locate
and secure the air panel to the wall (see Picture #3).
7WRAPLICENSE001
ELECTRICAL
115 VAC, 1 PH, 1 AMP
PNEUMATICS
2 SCFM @ 100 PSI
RUBBER BUMPER , JAM NUT and ROD END CLEVIS
MOUNT and CLEVIS
MOUNT and CLEVIS
