© Motor City Wash Works, Inc. 48285 Frank, Wixom Michigan 48393 U.S.A.
Phone: 248.313.0272 ▪ Fax: 248. 313.0271
8MANLWRPCROVR01 09-16-20
www.motorcitywashworks.com
45
correct port.
Crossover Wraps
Brush wobbles or
appears bent.
This problem is
typically event driven
causing damage to
the drive shaft.
Inspect the hub
clamps.
Crossover Wraps
Brush(es) do not
come to center before
vehicle arrives.
Check retract ready
signal is on soon
enough to allow
brushes to center
before vehicle arrives.
Verify primary arm
limits switch(s) are
functioning properly.
Verify the secondary
air pressure is set
high enough.
Verify secondary
stops are not limiting
full travel to center.
Crossover Wraps
Brush(es) do not
complete the washing
of the rear of a
vehicle.
Verify retract signal is
not turning off to soon.
Ensure primary arm
has engaged limit
switch(s).
Verify primary arm
limits switch(s) are
