MOTO GUZZI Daytona RS, Руководство по ремонту

Страница: 15 / 516

13
3.5 CLUTCH LEVER («G» IN Fig. 03-02)
This is on the left handlebar and is only to be used when starting or changing gear.
3.6 STARTER BUTTON AND ENGINE STOP SWITCH (Fig. 03-03)
These are mounted on the right handlebar.
With the key «1» in Fig. 03-01 in position ON «
», the vehicle is ready for starting.
To start the engine:
■
check that switch «B» is in position (run);
■
pull the clutch lever in to disengage the clutch fully;
■
if the engine is cold, put the «CHOKE» control «F» in the starting position «1» (see Fig. 03-02).
■
press the starter button A «» (start).
To stop the engine in case of emergency:
■
turn the switch «B» to position (off).
Once the engine has stopped, turn the key switch Fig. 03-01 in position OFF « » remove the key from the switch.
NOTE: Before start, put switch «B» in (RUN) position.
3.7 THROTTLE TWIST GRIP («C» in Fig. 03-03)
The throttle control is on the right handlebar; turning the twist-grip towards the rider opens the throttle, turning
it away from the rider closes it.
3.8 BRAKE LEVER, FRONT BRAKE («D» in Fig. 03-03)
This is on the right handlebar and controls the master cylinder of the front brake.
3.9 BRAKE PEDAL FOR REAR BRAKE («A» in Fig. 03-04)
This is centrally located on the right side of the vehicle and is linked to the rear brake master cylinder by a tierod.
3.10 GEARBOX CONTROL PEDAL (Fig. 03-05)
This is situated on the left of the motorcycle:
■
1st gear: push pedal down;
■
2nd, 3rd, 4th, 5th gears: pull pedal up;
■
neutral: between 1st and 2nd gears.
NOTE: Before changing gear disengage the clutch fully.
03-04
03-04
DAYTONA RS / SPORT 1100 I V10 CENTAURO
03-05
DAYTONA RS / SPORT 1100 I
03-05
A
A
V10 CENTAURO