B-80 MANUAL OPERATION
17-2-2
Adjusting the Work Rest (with the Workpiece Unloading Function)
Adjust the work rest position by following the procedure described below.
<Procedure>
1)
Extend the work rest with no workpiece on it.
•
Perform the work rest OUT operation from the WORK REST MANUAL OPERATION
screen.
•
Use a T-code to index the jig for pulling out the workpiece mounted between tools on
the turret.
Refer to the programming manual provided separately.
2)
Retract both the work rest and jig for pulling out the workpiece to positions where they will
not interfere with the workpiece.
•
Loosen the screws for adjustment in the X, Y and Z directions to retract the work rest.
•
Retract the jig for pulling out the workpiece in the X-axis plus direction in handle feed.
3)
Hold the workpiece with the chuck and the tailstock.
4)
Adjust the position of the work rest (X-/Y-/Z- direction).
Loosen the hexagon socket head cap screws on the spindle-side work rest and adjust the
position in each direction.
Adjust the clearance between the work rest and the workpiece so that the center comes
into the center hole range indicated by the arrow A in the illustration below. If the
clearance is too small, the work rest may interfere with the workpiece.
