E-16 PREPARATION BEFORE STARTING MASS PRODUCTION
18)
Press the
(START) and
(STOP) switches
alternately. Check the turret motion and the
displayed data on the PROGRAM screen.
Check the interference between the tool/chuck and
workpiece.
1.
The program stops at each block since the
single block function is valid.
However, press the
(STOP) switch if
the X- or Z-axis starts moving.
2.
Since the spindle OFF mode function is set
valid, the M code commands specified to be
executed are not executed in this state.
19)
Check the clearance between the cutting tool and
the chuck in comparison with the data for "DIST. TO
GO" which is displayed on the screen.
If there is a possibility of interference between the
tool and the chuck, stop no-load running and
correct the program. Then, check the program
again.
20)
After the completion of the first axis movement
block, select any of the following modes with the
mode selection switch.
(H)
(JOG)
(RPD)
(ZRN)
21)
With the manual door type machine, press the
DOOR UNLOCK switch
to unlock the front
door. Then open the front door.
With the automatic door type machine, open the
front door by pressing the AUTOMATIC DOOR
OPEN switch.
CYCLE
START
STOP
NOTE
NOTE
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
DOOR
UNLOCK
NOTE
