FOR SAFE OPERATION -33-
SO-NL-B17E/O
WARNING
8.
Some switches have transparent covers to prevent them from being
pressed by mistake. Keep these covers closed except when actually
pressing the switches. If a switch cover gets broken contact Mori
Seiki.
If these covers are kept open or are removed and a switch is pressed
unintentionally, the machine will operate in an unexpected manner,
causing accidents involving serious injuries or damage to the
machine.
9.
Pressing the feed hold switch during automatic operation stops axis
movement but does not stop spindle rotation. Therefore, select a
manual mode and confirm that spindle rotation has stopped before
opening the door. If you open the door while the spindle is rotating
you may be entangled with the spindle and seriously injured.
10.
Always stop the machine before removing chips inside it during
operation. Also stop the machine and coolant supply before
adjusting the direction or volume of coolant supply. If you attempt
these operations while the machine is operating you could be
seriously injured by being entangled in the revolving parts of the
machine or crushed by its moving parts.
11.
Before opening the front door to remove chips from inside the
machine during machining operation, make sure that the door
interlock function is valid. After removing the chips, close the front
door before restarting machine operation. If the machine interlock
function is invalid, it will be possible to open the door while the
machine is operating, and this could cause accidents involving
serious injuries or damage to the machine.
12.
Be aware that the machine will start automatic operation if the
(START) switch is pressed by mistake while the conditions required
to start automatic operation are satisfied and an automatic mode is
selected. If this switch is pressed carelessly, automatic operation
will start unexpectedly, and this could cause accidents involving
serious injuries or damage to the machine.
13.
If the single block function is made valid during automatic operation,
the next block is stored in the buffer register.
To stop the process currently being executed in order to execute
another process in this condition (i.e., with the data for the next
block stored in the buffer register), clear the data in the buffer
register by pressing the reset key. If you attempt to execute another
process while the data is still stored in the buffer memory, the
machine will operate in an unexpected manner, and this could cause
accidents involving serious injuries or damage to the machine.
