Morgana Digifold Pro CB, Руководство по обслуживанию

Страница: 80 / 92

Page 80
Calibration
This is the final calibration procedure and closely follows the 'Calibration' flow chart. You
must have completed all previous setup procedures leading up to this final calibration.
If additional information is required for setting up the various crease and fold variations,
please refer to the operators manual.
The delivery roller needs to be calibrated to ensure the correct positions are achieved
during automatic setup. In the 'Tools' menu adjust the 'Delivery Roller Trim' until the upper
stopping position is within 3mm of the perforator cover.
Using the test stock, setup 'Crease Only' at 50 and 370, Check the crease positions and
using the 'Stretch' and 'Lead Edge' settings in the 'Tools' menu, adjust the crease positions
until they are correct.
- Always Set the Stretch first i.e. 320mm between creases.
23.1. Using the test stock, setup 'fold only' (ie turn off creasing) at 100 and 250.
Check the fold positions and adjust if necessary using the 'Fold 1'
and 'Fold 2' adjustments in the 'Tools’ Menu.
Do not use damaged Test Stock.
21.
22.
23.
Delivery Roller
Crease Positions - Set by Position.
NOTE
Fold Positions - Set by Position.
WARNING.
CREASING / FOLDING