Morgana Digifold Pro CB, Руководство по обслуживанию

Страница: 36 / 92

Page 36 CREASING / FOLDING
SECTION L
Perforator Unit
Replacing the Gas Strut
To Replace the gas strut first assemble the bottom shoulder bolt into its location and
tighten using a 3mm allen key.
With the dog point located in the shaft mark the shaft and the link plate such that you are
able to realign the dog of the socket set screw when required.
Loosen the soc set screw allowing the link to rotate about the shaft and locate the top
shoulder bolt into the gas strut end and the link plate, tighten using a 3mm allen key. ref
illustration below.
Using an adjustable or large spanner positioned as shown below, compress the gas strut
until the soc set screw aligns with the hole in the shaft and tighten the screw.
Remove the allen key and relocate to allow a tightness torque of 2.2 Nm.
Release the compression and recheck torque.