Morgana Digifold Pro CB, Руководство по обслуживанию

Страница: 72 / 92

Page 72
NOTE
Delivery Damping
NOTE
- It may be necessary to re-tension the layside delivery roller drive belt. If so, do that
now before proceeding to the next step.
16.2.2.10. See section 20. for calibration of the delivery roller.
16.3.
For the delivery to raise and lower correctly it is necessary to set the damping level of the
supporting Gas strut that keeps it in position.
To adjust this gas strut use the following method;
16.3.1. Raise the delivery to its operational position.
16.3.2. Push the delivery down about 30 degrees and hold it.
16.3.3. Using a 10mm spanner, loosen the damping adjuster screw securing nut by
1/8th of a turn.
16.3.4. Release the delivery to its operating position.
16.3.5. Using a 3mm Allen key adjust the damping adjuster screw.
- Turning the screw will some of the damping, and vice versa.
16.3.6. Adjust until the desired damping effect is achieved, i.e. the delivery lifts all the
way up without assistance BUT does not move so quickly that it is likely to
damage something.
16.3.7. Push the delivery down about 30 degrees and hold it.
16.3.8. Using a 10mm spanner, tighten the damping adjuster screw securing nut.
clockwise remove
CREASING / FOLDING