Morgana Digifold Pro CB, Руководство по обслуживанию

Страница: 10 / 92

Page 10 CREASING / FOLDING
SECTION A
A.4
A.5
The Control Cover
The Top Cover Assembly
The Control Cover fixes to the front of the machine and supports the control cover door hinge,
with the door attached.
To remove completely wiil give very little access to anything, however opening the door
beneath the feed table gives access to the main electric controls.
To open this door remove the six posi pan head screws and pivot forwards.
To close is the reverse procedure.
Note. ensure this is securely closed when finished as mains electricity is present inside.
The Top Cover Assembly is hinged on top of the Machine and covers the Mechanism, this
hinges upwards to allow
access to the Main Rollers, the Input Rollers, the Creasing
Assemblies & the Top Sensors.
This cover can be removed from the machine as follows.-
1.
Open the Lay Side Door as previously described.
2. Open upwards.
3. Peel back the sound absorbent foam to allow access to the two posi pan head fixing
screws which can be unscrewed from the pivot shaft.
4.
From the rear of the machine slide the guard pivot shaft out taking care not to damage
the microswitch. the cover can now be removed. Take care not to lose/drop the nylon washers
at each end of the pivot shaft.
To replace is the reverse procedure, ensure the micro switch is correctly set after this
procedure.