Mold-Masters Fusion G2, Руководство пользователя

Страница: 54 / 192

6. Tighten the piston top to a torque of 10 Nm (7 lb-ft).
CAUTION
Use a soft jaw vise with the piston body to prevent damage to the part.
4.10 Adjust Valve Pin Length for Waterless
Actuator (Optional)
WARNING
Surfaces may retain heat. Always use personal protective equipment.
This procedure is optional for situations in which the valve pin length requires
adjustment.
7. Check the required adjustment of valve pin length in hot condition.
8. Cool down the system to room temperature, between 10°C and 40°C
(50°F and 104°F), and remove valve pin from piston.
9. Refer to Table 4-1 to choose the correct spacer combination for the length
adjustment.
Table 4-1 Valve Pin and Spacer Combinations
Valve
Pin
Length
Valve Pin
Adjustment
Under Pin Head Above Pin Head
Spacer
Combination
Total
Thickness
Spacer
Combination
Total
Thickness
Shorten
(pin too
long)
-0.20 A and C 4.40 A* and C* 4.20
-0.10 C and D 4.50 A* and B* 4.10
Nominal 0.00 B and C 4.30 A* and D* 4.30
Lengthen
(pin too
short)
+0.10 B and D 4.20 B* and D* 4.40
+0.20 A and B 4.10 C* and D* 4.50
*A thickness = 2.00 mm *C thickness = 2.20 mm
*B thickness = 2.10 mm *D thickness = 2.30 mm
4-23
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
PREPARATION
FSG2 User Manual