9.25 Belt Tension Adjustment
WARNING
Lockout / tagout machine before performing a belt tension adjustment.
1. Remove front and rear guards.
1
2
1. Rear guard
2. Front guard
2. Loosen, but do not remove, the screws securing the eccentric shaft
locking plate.
1
1. Eccentric shaft
locking plate screws
2. Eccentric shaft
2
3. Rotate the eccentric shaft until correct belt tension is achieved. See “Belt
Tension Specifications” on page 9-2.
4. In a cross-pattern, tighten the eccentric shaft locking plate screws and
torque. See “Screw Torque Specifications” on page 9-1.
5.
Check belt tension again to ensure it is within specification. Repeat steps
2 to 4 if necessary.
6. Reinstall the front and rear guards. Make sure the gap between the
guards and the injection housing is the same all around the housing. Also
make sure there is no interference with heater and thermocouple wires.
9-41
MAINTENANCE
E-Multi User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.