Mobotix MxEasy, Руководство пользователя

Страница: 11 / 132

11
/132
Setting Up A Video Surveillance System – Overview
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
1.3 Setting Up A Video Surveillance System – Overview
We will describe the most important steps for basic installation in this section. These steps
are the same for all scenarios.
For thorough instructions regarding camera installation, see the section Installation in the
corresponding Camera Manual. For information on the power supply and connecting
cameras to the network, see the section
Connecting The Camera To The Network And To
The Power Supply in the corresponding Camera Manual.
Mounting And Connecting The Cameras
•
Installing the Ethernet cable and mounting the cameras:
Determine where you want
to mount the cameras. Run the Ethernet cable to the mounting position of the camera.
Mount the cameras and connect the Ethernet cable to the corresponding camera:
– In the House example, one camera (Q24M) is mounted over the front door and
the other camera is mounted behind the house under the roof overhang.
– In the
Gas Station
example, two D24M-Sec cameras monitor the pumps in order
to record persons and vehicles in the area. The shop camera is mounted in one
corner of the room and the register camera is mounted on the ceiling above the
cash register area so as to monitor both customers and the register.
– In the
Hotel
example, one Q24M-Sec is mounted at the main entrance of the
hotel and the corresponding ExtIO is mounted next to the door of the main
entrance where it serves as a door intercom. Two M24M-R16 cameras monitor
the entrance and the rear side of the underground garage. The remaining five
Q24M-Sec cameras are installed in the planned positions using In-Ceiling Sets
(in the hallways of the second and third floors, in the swimming pool area, in
the gym, and above the reception desk). The camera above the reception desk
is mounted in the ceiling so as to monitor the entire reception area.
•
Setting up the power supply:
Set up the power supply of the camera. Use either a
commercial PoE switch, MOBOTIX Network Power Racks/Boxes or
MOBOTIX power
supply units
in conjunction with
Network Power Adapters
.
•
Connecting the cameras:
Connect the Ethernet cable from the cameras to the PoE
switch (or the Network Power Rack/Network Power Adapter). The PoE switch is con-
nected to the local area network (LAN) via another Ethernet cable.
•
Checking the cameras:
Inspect the LEDs of the operating cameras to make sure
that they indicate that the camera is operating normally.
The MOBOTIX cameras are now ready to use and available in the local area network.
They can now be integrated into MxEasy.