Miyachi Unitek ISA Series, Руководство оператора

Страница: 82 / 122

APPENDIX C: SYSTEM TIMING
ISA-4001CR INVERTER POWER SUPPLY
C-6 990-364
Chaining Function
The
Chaining
function operates by allowing a sequence of Schedules to be performed as long as
Stage 2
input signal is maintained. The schedules used for the chaining are set at
Chaining
in the
Schedule
screen.
Example: A
Stage 2
start (without a
Stage 1
signal) causes the weld sequence to begin as a
Stage 1
start. (A
Stage 2
start would operate in the same manner except for the actual start sequence, as
described above.) As shown, if the
Chaining
was set ON for Schedules 1, 2, 5, and 6, but OFF for other
Schedules, the sequence would go through that sequence, but , because of the loss of the
Stage 2 Input
,
would terminate
after
the completion of Schedule 5; Schedule 6 will not be performed. Another
Stage 2
input would cause the sequence to begin again at
Schedule 1
.
Chaining Function