Mitsubishi MOTORS Outlander Sport 2019, Руководство пользователя

Страница: 86 / 361

Free-hand Advanced Security Transmitter (F.A.S.T.-key) (if so equipped)
Features and controls 5-21
5
4. Make sure the selector lever is in the “P”
(PARK) position.
5. Press the engine switch.
6. Confirm that all warning lights and warn-
ing displays are functioning properly.
After several attempts, you may experience
that the engine still does not start.
1. Make sure that all electric devices, such
as lights, air conditioning blower and rear
window defogger, are turned off.
2. While depressing the brake pedal, press
the accelerator pedal halfway and hold it
there, then crank the engine. Release the
accelerator pedal, immediately after the
engine starts.
3. If the engine still will not start, the engine
could be flooded with too much gasoline.
While depressing the brake pedal, push
the accelerator pedal all the way down
and hold it there, then press the engine
switch to crank the engine. If the engine
does not start after 5 to 6 seconds, push
the engine switch to stop cranking the
engine, and release the accelerator pedal.
Put the operation mode in OFF. Wait a
few seconds, and then press the engine
switch to crank the engine again while
depressing the brake pedal, but do not
push the accelerator pedal. If the engine
fails to start, repeat these procedures. If
the engine still will not start, contact your
local Mitsubishi Motors dealer or a repair
facility of your choice for assistance.
Startability of the engine with an ambient
temperature of
-22 °F (-30 °C) or lower
When the ambient temperature is -22 °F (-30
°C) or lower, it may not be possible to start
from a standstill even with the selector lever
in the “D” (DRIVE) or “R” (REVERSE)
position.
This phenomenon occurs because the trans-
axle has not warmed up sufficiently; it does
not indicate a problem. If this occurs, place
the selector lever in the “P” (PARK) position
and let the engine idle for at least 10 minutes.
The transaxle will warm up, and you will be
able to start normally.
Do not leave the vehicle during warm-up
operation.
N00568201066
NOTE
 After the engine has not started for a while,
the brake pedal effort needed to start the
engine may become greater. If this occurs,
depress the brake pedal more firmly than
usual.
NOTE
 The engine can only be started when the
selector lever is in the “P” (PARK) or “N”
(NEUTRAL) position.
For safety reasons, the engine should be
started when the selector lever is in the “P”
(PARK) position in which the driving wheels
lock.
NOTE

Minor noises may be heard on engine start-
up. These will disappear as the engine warms
up.
When the engine is hard to start
Stopping the engine
WARNING
 Do not operate the engine switch while
driving except in an emergency. If the
engine is stopped while driving, the brake
servomechanism will cease to function and
braking efficiency will deteriorate. Also,
the power steering system will not func-
tion and it will require greater manual
effort to operate the steering. This could
result in a serious accident.
NOTE
 If you have to bring the engine to an emer-
gency stop while driving, press and hold the
engine switch for 3 seconds or more, or press
it quickly 3 times or more. The engine will
stop and the operation mode will go to ACC.
BK0265500US.book 21 ページ ２０１８年５月８日 火曜日 午後８時７分