Mitsubishi MOTORS Outlander Sport 2019, Руководство пользователя

Страница: 217 / 361

Combination headlights and dimmer switch
5-152 Features and controls
5
The sensitivity of the sensor can be temporar-
ily lowering in the following ways.
1. Park your vehicle in a safe place and the
ignition switch is turned to the “OFF”
position or the operation mode is put in
OFF.
2. Press the AHB switch more than 15 times
within 5 seconds after operation mode is
turned on.
N00593800072
If a problem occurs with the system, the fol-
lowing warning display will appear to the
type of the problem.
If a failure is detected in the system, the fol-
lowing warning display will appear and the
AHB will automatically be turned off.
If the warning display remains even after the
ignition switch is turned to the “OFF” posi-
tion or the operation mode is put in OFF and
then turned back to ON, please contact an
authorized Mitsubishi Motors dealer.
[When the AHB is malfunctioning]
 The AHB recognises environmental condi-
tions by sensing a light source ahead of your
vehicle. Therefore, you may feel like some-
thing is not quite right when the headlight
beams are switched automatically.

The system may not detect a light vehicle
such as a bicycle.
 The system may not detect an ambient
brightness precisely. This causes the traffic
to be dazzled by high beam or the low beam
to be maintained. In such cases, you should
switch the headlight beams manually.
• In bad weather (heavy rain, fog, snow or
sandstorm).
• The windshield is dirty or fogged up.
• The windshield is cracked or broken.
• The sensor is deformed or dirty.
• A light, which is similar to the headlights or
tail lights, is shining around your vehicle.
• A vehicle in front or oncoming vehicle is
driven without lights, the exterior lights are
dirty or discolored, or the direction of the
headlight beams is adjusted improperly.
• It becomes dark and bright suddenly and
continuously around your vehicle.
• Your vehicle is driven on uneven surfaces.
• Your vehicle is driven on a winding road.
• A reflective object such as a noticeboard or
a mirror reflects a light ahead of your vehi-
cle.
NOTE
• When lights of the vehicle in front or head-
lights of an oncoming vehicle blend into the
other lights.
• The rear end of a vehicle in front (such as a
container truck) reflect a strong light.
• Your vehicle’s headlight is broken or dirty.
• Your vehicle is inclined due to a flat tire or
towing.
• The warning display appears.
(Refer to “System problem warning” on
page 5-152.)

Observe the precautions below to maintain
good usage conditions:
• Do not attempt to disassemble the sensor.
• Do not affix a sticker or label on the wind-
shield near the sensor.
• Avoid overload.
• Do not modify your vehicle.
• When the windshield is replaced, use the
Mitsubishi Motors genuine parts.
To adjust the sensitivity of the sensor
NOTE
System problem warning
 The AHB deactivation due to fault
BK0265500US.book 152 ページ ２０１８年５月８日 火曜日 午後８時７分