Mitsubishi MOTORS Outlander Sport 2019, Руководство пользователя

Страница: 271 / 361

Automatic air conditioning-Type1 (if so equipped)
7-12 Comfort controls
7
Push the switch again and the air condition-
ing compressor will stop and the indicator
light (A) goes off.
N00759800045
You can change the following functions to
match your preference.
 Enable automatic air conditioning control:
When the mode selection dial or blower
speed selection dial has been set to the
“AUTO” position or when the tempera-
ture control dial has been set to the mini-
mum temperature, the air conditioning
switch is automatically controlled.
 Disable automatic air conditioning con-
trol:
The air conditioning switch is not auto-
matically controlled, unless the air condi-
tioning switch is used.
 Changing the settings
Press the air conditioning switch for about
10 seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled,
the system will beep three times and the
indicator will flash three times.
• When the setting has changed from dis-
abled to enabled,
the system will beep two times and the
indicator light will flash three times.
N00731701586
In normal conditions, use the system in the
AUTO mode and follow these procedures:
NOTE
 If a problem is detected in the air condition-
ing compressor, the air conditioning indica-
tor light (A) blinks. Press the air
conditioning switch once to turn it off, then
once more to turn it back on. If the air condi-
tioning indicator light does not blink there is
no problem. If it does blink, have it checked
at an authorized Mitsubishi Motors dealer or
a repair facility of your choice.
 Sometimes, for example after using a high-
pressure car wash, the condenser can get wet,
and the air conditioning indicator light (A)
blinks temporarily. Wait for a while, press
the air conditioning switch once to turn the
system off, then once more to turn it back on.
Once the water evaporates, the blinking will
stop.
Personalizing the air conditioning
switch (Changing the function set-
ting)
NOTE
 The factory setting is “Enable automatic air
conditioning control”.

While the mode selection dial is set between
“
” and “ ” position, the air condition-
ing will run automatically, even if the system
is set to “Disable automatic air conditioning
control”, in order to prevent windows from
fogging up.
Operating the air conditioning
system (automatic mode)
BK0265500US.book 12 ページ ２０１８年５月８日 火曜日 午後８時７分