Mitsubishi MOTORS Outlander Sport 2019, Руководство пользователя

Страница: 71 / 361

Electronic immobilizer (Anti-theft starting system)
5-6 Features and controls
5
your vehicle at your Mitsubishi Motors
dealer) by doing the following:
1. Insert the first valid key into the ignition
switch and turn the key to the “ON” posi-
tion for 5 seconds.
2. Turn the key to the “OFF” position and
remove the first key.
3. Within 30 seconds of removing the first
key, insert the second valid key into the
ignition and turn it to the “ON” position.
About 10 seconds later, the immobilizer
display will start to blink.
4. When the immobilizer display starts
blinking, turn the second valid key to the
“OFF” position and remove it. Within 30
seconds after doing so, insert a blank
immobilizer key into the ignition switch
and turn it to the “ON” position. Perform
this operation no more than 30 seconds
after the immobilizer display starts blink-
ing. When registration of the ID code is
complete, the immobilizer display will
come on for 30 seconds then go off. If an
error occurs, the blinking immobilizer dis-
play will go off during the procedure.
5. If you wish to register another key, per-
form the process again from step 1.
N00562301124
Your electronic immobilizer operates on a
radio frequency subject to Federal Communi-
cations Commission (FCC) Rules (For vehi-
cles sold in U.S.A.) and Industry Canada
Rules (For vehicles sold in Canada). This
device complies with part 15 of FCC Rules
and Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE
 Perform the operation when the interrupt dis-
play screen is not showing. The interrupt dis-
play screen may prevent you from seeing the
immobilizer display.

It is not possible to register a key if:
• the immobilizer display goes off during the
procedure
• the immobilizer display does not come on
within 30 seconds after step 4.
 The procedure will be terminated automati-
cally if:
• a period of 30 seconds or longer elapses
from the moment when the first key is
turned to the “OFF” position to the moment
when the second key is turned to the “ON”
position
• a period of 30 seconds or longer elapses
from the moment when the second key is
turned to the “OFF” position to the moment
when the blank immobilizer key is turned
to the “ON” position

To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to “Keyless entry system: Cus-
tomer remote control transmitter program-
ming” on page 5-9.
General information
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
BK0265500US.book 6 ページ ２０１８年５月８日 火曜日 午後８時７分