Mitsubishi Electric FR-A820-00046 (0.4K), Инструкция по эксплуатации

Страница: 491 / 1218

Parameters (D) Operation command and frequency command
FR-A800 5 - 289
Selection of control source in Network operation mode (Pr. 338, Pr. 339)
●
There are two control sources: the start command source, which controls the signals related to
the inverter stand command and function selection, and the speed command source, which
controls signals related to frequency setting.
●
The table below shows the commands from the external terminals and communication (RS-485
terminals or communication option) in the Network operation mode.
Operation
location
selection
Pr. 338 "Communication operation command
source"
0: NET 1: EXT
Remarks
Pr. 339 "Communication speed command source" 0: NET 1: EXT 2: EXT 0: NET 1: EXT 2: EXT
Fixed function
(terminal-
equivalent
function)
Running frequency from communication NET
⎯
NET NET
⎯
NET
Terminal 2
⎯
Exter-
nal
⎯ ⎯ ⎯ ⎯
Terminal 4
⎯
External
⎯
External
Terminal 1 Compensation
S
e
le
c
tab
le
func
tion
P
r.
17
8 to P
r.
1
89
setti
ng
0 RL
Low-speed operation command/remote
setting
Clear/Stop-on-contact selection 0
NET External NET External
Pr. 59 = "0"
(multi-speed)
Pr. 59
≠
"0" (remote)
Pr. 270 = "1, 3, 11, or
13" (stop-on-contact)
1 RM
Middle-speed operation command/
remote setting deceleration
NET External NET External
2 RH
High-speed operation command/remote
setting acceleration
NET External NET External
3 RT
Second function selection/stop-on-
contact selection 1
NET External
Pr. 270 = "1, 3, 11, or
13" (stop-on-contact)
4 AU Terminal 4 input selection
⎯
Combined
⎯
Combined
5 JOG Jog operation selection
⎯
External
6 CS
Selection of automatic restart after
instantaneous power failure, flying start
External
7 OH External thermal relay input External
8 REX 15-speed selection NET External NET External
Pr. 59 = "0"
(multi-speed)
9 X9 Third function selection NET External
10 X10 Inverter run enable signal External
11 X11
FR-HC2/FR-CC2 connection, instantaneous
power failure detection
External
12 X12 PU operation external interlock External
13 X13 External DC injection brake operation start NET External
14 X14 PID control valid terminal NET External NET External
15 BRI Brake opening completion signal NET External
16 X16 PU/External operation switchover External
17 X17
Load pattern selection forward/reverse
rotation boost
NET External
18 X18 V/F switchover NET External
19 X19 Load torque high-speed frequency NET External
20 X20
S-pattern acceleration/deceleration C
switchover
NET External
22 X22 Orientation command NET External
23 LX Pre-excitation/servo ON NET External
24 MRS
Output stop Combined External Pr. 79 ≠ "7"
PU operation interlock External
Pr. 79 = "7"
When X12 signal is not
assigned.
25
STP
(STOP)
Start self-holding selection - External
26 MC Control mode switchover NET External
27 TL Torque limit selection NET External
28 X28 Start-time tuning start external input NET External
37 X37 Traverse function selection NET External
Tab. 5-113: Writing operation and speed commands (1)