Mitsubishi Electric FR-A820-00046 (0.4K), Инструкция по эксплуатации

Страница: 1017 / 1218

Parameters Ethernet communication (FR-A800-E)
FR-A800 5 - 815
– Reply code definition
The reply to the instruction execution is set to RWr2, 10, 12, 14, 16, 18.
When executing the frequency setting (RYD, RYE) or instruction code execution (RYF), check the
reply code (RWr2) in the remote register after execution.
The contents of the reply code 1 are changed when torque commands are given or the torque is
limited (when Pr. 544 = "14, 18, 24, or 28").
The upper 4 bits of the reply code 1 are used as the reply code to the torque command / torque
limit, and the lower 4 bits are used as the reply code to the frequency command.
Data Item Alarm definition Remarks
Reply code
H0000 Normal
No error (normal completion of
instruction code execution)
앫
Reply code to RWr2
when Pr. 544 = 0
앫
Reply code to RWw10,
12, 14, 16, and 18
when Pr. 544 = 18
H0001 Write mode error
Parameter write was attempted during
operation other than a stop in the
network operation mode.
H0002
Parameter selection
error
Unregistered code number was set.
H0003 Setting range error
Set data is outside the permissible
data range.
Reply code 1
H00 Normal
No error (normal completion of
instruction code execution)
Reply code to RWr2 when
Pr. 544 ≠ 0
H01 Write mode error
Parameter write was attempted during
operation other than a stop in the
network operation mode.
H03
Frequency command /
torque command /
torque limit setting
range error
The value outside the range is set.
Reply code 2
H00 Normal
No error (normal completion of
instruction code execution)
H01 Write mode error
Parameter write was attempted during
operation other than a stop in the
network operation mode.
H02
Parameter selection
error
Unregistered code number was set.
H03 Setting range error
Set data is outside the permissible
data range.
Tab. 5-405: Reply codes
b15 b0
Reply code 2
Reply code to the torque
command / torque limit
Reply code to the frequency
command
Reply code 1
Example The error code is H0030 when the torque command value is outside the setting range.
b15 b0
0 0 0 0 0 0 0 0 0 0 1 1 0 0 0 0
Reply code to the torque
command