Mitsubishi Electric FR-A820-00046 (0.4K), Инструкция по эксплуатации

Страница: 598 / 1218

(M) Monitor display and monitor output signal Parameters
5 - 396
5.11.9 Output torque detection
A signal is output when the motor torque is higher than the setting. This function can be used for elec-
tromagnetic brake operation, open signal, etc.
●
The Torque detection (TU) signal turns ON when the output torque reaches the detection torque
value set in Pr. 864 or higher. The TU signal turns OFF when the output torque drops lower than
the detection torque value.
●
Pr. 864 is not available under V/F control.
●
For the TU signal, set "35 (positive logic) or 135 (negative logic)" in one of Pr. 190 to Pr. 196 (output
terminal function selection) to assign the function to the output terminal.
E
CAUTION:
●
The zero current detection level setting should not be too low, and the zero current detection
time setting not too long. When the output current is low and torque is not generated, the
detection signal may not be output.
●
Even when using the zero current detection signal, a safety backup such as an emergency
brake must be provided to prevent hazardous machine or equipment conditions.
Parameters referred to
Online auto tuning => page 5-482
Offline auto tuning => page 5-72, page 5-471
Pr. 190 to Pr. 196 (output terminal function selection) => page 5-378
Pr. Name Initial value Setting range Description
864
M470
Torque detection 150% 0 to 400%
Set the torque value where the TU
signal turns ON.
Fig. 5-181:
Torque detection
I002630E
NOTE Changing the terminal assignment using Pr. 190 to Pr. 196 (output terminal function selection)
may affect the other functions. Set parameters after confirming the function of each terminal.
Parameters referred to
Pr. 190 to Pr. 196 (output terminal function selection) => page 5-378
Magnetic flux Magnetic flux Magnetic flux Sensorless Sensorless Sensorless Vector Vector Vector PM PM PM
TU
Time
Pr. 864
Output t
o
rq
ue
(%
)
ON OFF