Mitsubishi Electric FR-A820-00046 (0.4K), Инструкция по эксплуатации

Страница: 970 / 1218

CC-Link IE Field Network (FR-A800-GF) Parameters
5 - 768
Programming example for the fault record reading
The following program reads the fault records of the station 1 inverter to output to D1.
●
Faults history No. 1 and 2 reading instruction code: H74 (hexadecimal)
For the error code, refer to page 6-5.
The reply code (RWr10) to the instruction code execution is set in D2.
(Refer to page 5-756 for the reply code (RWr10).)
Programming example for resetting the inverter at an inverter fault
The following program resets the station 1 inverter at an inverter fault.
I003093E
Fig. 5-381: Programming example 7
I003094E
Fig. 5-382: Programming example 8
NOTES The inverter reset with the flag RY3A shown above is enabled at an inverter fault only.
When Pr. 349 "Communication reset selection" = "0", an inverter reset can be made in any opera-
tion mode.
When using the instruction code execution request (RY25) with the instruction code (HFD) and
data (H9696) to reset the inverter, set a value other than "0" in Pr. 340 "Communication startup
mode selection" or change the operation mode to the Network operation mode. (Refer to pro-
gram example 2 on page 5-763).
SET M301
PLS M300
MOV W11 D1
MOV H74 W110
SET Y1025
0
3
7
9
16
24
M0 X20
X1025
SB49
M302 X1025
M301
M300
RST M301
SET M302
MOV W10 D2
RST Y1025
RST M302
END
M0
SW0B0.0
Check the data link status of the station 1.
Read the fault record (RWr11) and the reply code (RWr10)
to output to D1 and D2 when the instruction code
execution completion (RX25) turns ON.
Write the faults history No.1 and No.2 read code (H74) to
RWw10.
Turn OFF the instruction code execution request (RY25).
Turn ON the instruction code execution request (RY25).
SB49
M0 X103A X20
0
3
7 END
Y103A
M0
SW0B0.0
Check the data link status of the station 1.
Turn ON the error reset request flag (RY3A).
Turn OFF the error reset request flag (RY3A) when the error
status flag (RX3A) is OFF.
Error status flag