Mitsubishi Electric F930GOT-BWD-E, Руководство пользователя

Страница: 23 / 274

Graphic Operation Terminal F930GOT Introduction 1
1-9
1.5.3 Connection of peripheral units of PLC
When a general-purpose personal computer is directly connected to the GOT, the two-port
interface FX-2PIF (two-port interface function) is not required.
When one GOT and one peripheral unit for sequence program creation are used for one PLC,
the two-port interface FX-2PIF is required. The system configuration required in this case is
shown below.
1
Graphic operation terminal
F930GOT-BWD-E
Data transfer cable FX-232CAB-1 (3 m) (when the RS-232C connector in
the PC is 9-pin type),
Data transfer
cable
FX-422CAB0
Connection cable FX-40DU-CAB (3 m) or Connection cable FX-40DU-CAB-10M (10 m)
Program cable FX-20P-CAB (1.5 m)
Programmable controller
Two-port
interface
FX-2PIF
When the two-port interface FX-2PIF is used
Data transfer cable AC30R4 (3 m)
When the two-port interface function is used, the operation environment should
be set for it.
(Refer to the description on "SERIAL PORT" on the SET-UP MODE screen.)
Data transfer cable FX-422CAB (0.3 m) or
Data transfer cable FX-422CAB-150 (1.5 m)
Data transfer cable FX-232CAB-2 (3 m)
(when the RS-232C connector in the PC is half-pitch, 14-pin type) or
Data transfer cable F
2
-232CAB-1 (3 m)
(when the RS-232C connector in the PC is 25-pin type)
2
3
FX/FX
2C
/ Series
FX
0
/FX
0S
/FX
0N
/FX
2N
/
FX
2NC
Series
A Series (except QnA)
(Refer to Paragraph 1.8.)
Motion controller
ž
ž
ž
ž ž