Mitsubishi Electric F700, Инструкция по эксплуатации

Страница: 154 / 341

145
Operation setting at fault occurrence
4
PA
R
A
M
E
T
E
R
S
4.13.2 Fault code output selection (Pr.76)
˜
By setting Pr. 76 to "1" or "2", the fault code can be output to the output terminals.
˜
When the setting is "2", a fault code is output at only fault occurrence, and during normal operation, the terminals
output the signals assigned to
Pr. 191 to Pr. 194 (output terminal function selection) .
˜
The following table indicates fault codes to be output. (0: output transistor off, 1: output transistor on)
At fault occurrence, its description can be output as a 4-bit digital signal from the open collector output terminals.
The fault code can be read by a programmable controller, etc., and its corrective action can be shown on a
display, etc.
Parameter
Number
Name Initial Value Setting Range Description
76 Fault code output selection 0
0 Without fault code output
1
With fault code output
(Refer to the following table)
2
Fault code output at fault occurrence
only
(Refer to the following table)
The above parameters can be set when Pr. 160 User group read selection = "0". (Refer to page 173)
Operation Panel
Indication
(FR-DU07)
Output of Output Terminals
Fault Code
SU IPF OL FU
Normal * 0 0 0 0 0
E.OC1 0 0 0 1 1
E.OC2 0 0 1 0 2
E.OC3 0 0 1 1 3
E.OV1 to E.OV3 0 1 0 0 4
E.THM 0 1 0 1 5
E.THT 0 1 1 0 6
E.IPF 0 1 1 1 7
E.UVT 1 0 0 0 8
E.FIN 1 0 0 1 9
E. BE 1 0 1 0 A
E. GF 1 0 1 1 B
E.OHT 1 1 0 0 C
E.OLT 1 1 0 1 D
E.OPT 1 1 1 0 E
E.OP1 1 1 1 0 E
Other than the above 1 1 1 1 F
* When Pr. 76 = "2", the output terminals output the signals assigned to Pr. 191 to Pr. 194 .
CAUTION
˜
When a value other than "0" is set in Pr.76
When a fault occurs, the output terminals SU, IPF, OL, FU output the signal in the above table, independently of the
Pr. 191 to
Pr. 194 (output terminal function selection) settings. Please be careful when inverter control setting has been made with the output
signals of Pr. 191 to Pr. 194 .
i
Parameters referred to
i
Pr. 191 to Pr. 194 (output terminal function selection) Refer to page 116