Mitsubishi Electric City Multi CMB-P1016NU-G, Руководство по обслуживанию

Страница: 137 / 349

- 128 -
[
VII
Control ]
3. Function of the switch <Remote controller>
ME remote controller (PAR-F27MEA-US-E)
Set the address of the remote controller with the rotary switch.
Note: To set addresses, use a precision slotted screw driver [2.0 mm [0.08 in] (w)], and do not apply than 19.6N.
The use of any other tool or applying too much load may damage the switch.
4. BC controller (Main board)
Model setting
012
34
567
8
9
012
34
567
8
9
012
34
567
8
9
012
34
567
8
9
10's digits 1's digits
(left) (right)
Remote controller unit
Rotary switch
Example: In case of address 108
Address setting range Setting method
Main remote controller 101-150 Add 100 to the smallest address of all the indoor units in the
same group.
Sub remote controller 151-200 Add 150 to the smallest address of all the indoor units in the
same group.
Setting of rotary switch Address No.
01-99
*1
101-199 with the 100's digit automatically being set to 1
*2
00 200
*1. At factory shipment, the rotary switch is set to 01.
*2. The address range that can be set with the ME remote controller is between 101 and 200. When the dials are set to
a number between 01 and 99, the 100's digit is automatically set to [1]. When the dials are set to 00, the 100's digit is
automatically set to [2].
Switch Function Function according to switch setting Switch setting timing
OFF ON
SW4
1 Model setting R410A - Always leave it to OFF
2-8 - - - -
SW5
1-6 - - - -
7 Model setting Refer to the table below for details. Before power on
8 Model setting Refer to the table below for details. Before power on
SW5-8
OFF ON
SW5-7
OFF G type
ON GA type GB type