Minebea CSD-903-EX, Инструкция по эксплуатации

Страница: 85 / 226

69
● PRELIMINARY 2
Set the value of PRELIMINARY 2.
Setting range
：
000000-999999 Unit
：
1D
Default is set to [000000].
In the sequential mode, when the value of [FINAL(SET1) – PRELIM 2(SET4)] is obtained the F.FLOW
output will be ON, and in the simple comparative mode the F.FLOW will be OFF when arrived at the
value of [FINAL(SET1) – PRELIM 2(SET4)].
When the setting is [FINAL
≧ PRELIM 2] , [PRELIM 1 ≧ PRELIM 2] or [F.FLOW ≦ PRELIM 2], it
becomes SQ.ERR 3 at the time of start signal is inputting.
● OVER
Set the value of OVER.
Setting range
：
00000-99999 Unit
：
1D
Default is set to [00000]
When the measurement result [FINAL (SET1) + OVER (SET5)] is exceeded, the over output is turned
on.
● UNDER
Set the value of UNDER.
Setting range
： 00000-99999 Unit ： 1D
Default is set to [00000].
When the measurement result [FINAL (SET1) - UNDER (SET6)] is exceeded, the under output is
turned on.
● ZERO BAND
Set the value of Near zero.
Setting range
：
00000-99999 Unit
：
1D
Default is set to [00000].
When the measurement result is under the value of [FINAL (SET1) - OVER (SET5)], the under output
will be on.
● FULL
Set the value of FULL.
Setting range
：
000000-999999 Unit
：
1D
Default is set to [000000]
When the Gross weight or the Net weight exceeds the Full value, the FULL output will be ON.
Please set the stored place to the internal RAM when the set value is continuously changed, and the
rewritable time of EEPROM might exceed about one million times.